Beckons for winter fishing rods: species selection. Homemade nod for winter fishing rods

Any known that for successful fishing in the first place need a good tackle. In winter, the fish catch on bespoplavochnuyu bait, the main element of which is a nod. It is for him angler detects light bite and makes cutting.

What nod?

Nod, otherwise it is called cock - part of the winter fishing rod, which provides the game and gives the bait fisherman signal biting. It is attached to whip by means of clamp, tape, wire or rubber ring.

Winter fishing rod with a nod used to catch any fish. It is important to choose the length and hardness of the material. Hard nods for winter fishing rods turn a tackle in the stick, and too soft will range from wind and water currents.

In which case, a nod?

Winter fishing rod can be equipped with a float or a nod. In the first case, the rod is equipped with a coil and a fishing line with a float, which warns about the biting. Often such tooling used for fishing on the hook with bait. In winter, the cold weather well is quickly tightened the ice, and it becomes difficult to keep track of the float.

In this case, fishermen use the nod. Sometimes nods for winter fishing rods use and packed without bait. Its advantage lies in the fact that it is located above the water, so do not obledenevaet and responds well to bite, allowing slow and fast play bait.

Types of materials

For the manufacture of nods use very different materials. Should be considered when choosing its rigidity, low temperature and deformation resistance. Nod for winter fishing rods with their own hands can be made of the following materials:

• Sheet Mylar (film) - the best-known material, is used when using a lodge with a jig and bloodworms, small game lure has a good sensitivity.
• Plastics (different types) - a lightweight material. Beckons made of him playing well.
• boar bristles and wool - a natural material, has a good sensitivity with time pushitsya, the cold becomes brittle.
• Bamboo - lightweight natural material does not freeze in the cold.
• metal strips, springs. Metal nods are universal: work with light and heavy spoons. They are excellent signals about biting on current and deep water. Spring - retain their elasticity, reacts to weak bite. The disadvantage of a nod, made of spring, is that the line sometimes gets between the spring curls and movement that it provides, do not give the lure a quality game, but rather like the jolting.

Types nods

Tackle is classified by the type of material stiffness. Given this criterion, the following types of nods for winter fishing rods:

• soft - used in waters with no strong currents can catch any species of fish;
• medium - application is the same as that of the soft Gatehouse;
• Heavy - used for angling fish in waters with a rapid current or strong gusts of wind;
• superheavy - operated at catching fish from a depth of more than 5 meters, and in extreme conditions.

How to pick up a nod for winter fishing rod?

Proper selection of tackle, given its weight, size and feature of the game is of paramount importance in the selection of a nod.

• Beckons for fishing bezmotylki. When the under-ice-fishing fish fishing tackle that has no attachment, misconfigured cock leave fishermen without a catch. In this case, the necessary uniform and monotonous game jig with a stable job nod. For this hole located on the end of a nod, should be slightly larger than the diameter of fishing line, tackle otherwise be unmanageable. The line should be passed through tubing that is inserted onto the working part of a nod, or a nod of the arc of line will hang out and lure game will be unstable. Beckons for winter fishing rods are made of Dacron or a thin plastic sheet to obtain the softest lodge. Catch small fish: roach and perch.
• Beckons for fishing jig have to be more versatile. When using a light jig length decreases, and if severe - increases. Cock adjusted so that it transmits vibrations mormyshke rod, and at the same time has a stiffness.
• Beckons vertical trolling must be made of thick line and have a small length. Storozhok to lure the game has no effect on him only determine the perfect bite. Suitable for fishing in large perch.
• Beckons to balance depend on the mass of the latter. Storozhok should clearly indicate the beginning of a take and touch the surface of the rocker bottom. Well suited silicone or lavsan cock in length from 4 to 7 cm. Often used for its manufacture and a thin coil spring. To whip it joins the movable mount, so you can quickly change the length and stiffness. These nods for winter fishing rod designed for catching large predator trolling.

nod Shcherbakova

For angling cautious fish fishermen sometimes use side Gatehouse. They nod is perpendicular whip. In this case, it becomes more sensitive.

Nod Shcherbakova, otherwise it is called the pointer or the bearing, it is a form of lateral nod.

The entire device consists of a small bearing which is worn on the whip bits, and metal arrows upwardly soldered work surface.

Balance weight is on one end of the arrow, and the other placed a loop through which a fishing line. bait and weight of the load mass must clearly be consistent with each other.

Nod Shcherbakova accurately captures the bite and movement of the beam can be done cutting. He simply install, reliable in operation, and the fishermen say that this is the best nod for winter fishing rod.

Requirements for nods

For manufacturing lodge using elastic materials which do not change their structure when loads and low temperatures in the winter.

Fisherman must always have a spare few nods to be able to change or replace the damaged.

Homemade nod for winter fishing rod or a nod, bought in fishing shop should be well-adjusted.

If you are going on a fishing trip, you should check the deviation angle of the lodge, it is usually 30-45 degrees. This is done by using a protractor school.

Pay particular attention to the sensitivity of the nod. It is directly dependent on its shape and length. With little susceptibility to lodge a biting it may not be noticed.

Length purchased nod average of 6 cm, depending on the manufacturer.

Tackle purchased in specialty stores, do not always meet the needs of anglers. They do not attach to the whip, the material in the rings of a non-elastic and thick. Fishing enthusiasts will improve often bought or make homemade nod for winter fishing rod from the material at hand.

Production nods

Nod, made with his own hands experienced anglers, is as good as produced by the manufacturer and sometimes surpasses it. Make them different in the material used and the shape, considering the personal experience.

More and more fishermen are trying to fish on homemade nods. Using them is easy to adjust the gear in all respects, and even make the original color. For manufacturing nods using any materials that are at hand. We need only a little dream. How to make a nod for winter fishing rods, discussed below.

nod of clock spring

1. The spring of hours to straighten the scissors and cut 15 cm.
2. The edges of the cut, leaving one end in a width of 2 mm.
3. The surface and sides of the handle with sandpaper, removing all roughness.
4. make a loop of wire, the diameter of which is smaller than the width of the tip of the spring, it will vertex nod.
5. The loop is soldered to the truncated side of the spring.
6. Place the soldering sandpaper.

nod for winter fishing rods of the spring ready. It is used to catch perch and roach on a fishing tackle, bait, or without it.

A nod of the coil spring

When fishing on the balancer used hard cock, it can be made from a twisted spring. This will require:

• wire diameter 0, 5 mm copper;
• spring steel 15 cm;
• emery paper;
• polyethylene tube;
• file;
• acid soldering and solder;
• nail polish;
• metal cutting shears.

1. Cut spring scissors and polished sections of a file and sandpaper.
2. make a loop of wire, the diameter of which is smaller than the width of the tip of the hut.
3. The loop is soldered to the spring so that the ball appeared when docking.
4. soldering clean, the upper part of the paint finish.
5. From cambric cut two rolls of 10 mm and put on cock.

nod for winter fishing rods with their hands after manufacture should be adjusted by increasing or decreasing its length. It should be noted that the model stiffness should coincide with the mass of bait that is used.

Tackles for catching ripus

Nod "Flapper" for winter fishing rods have successfully used when fishing for salmon family of fish in the northern lakes.

For the manufacture of fishing rod and a nod is required:

• rod "Dolphin";
• one-piece carbon fiber or carbon fiber whip;
• tyulpanchik;
• gum for fixing nod;
• nod of the clock spring;
• Silicone tubing;
• epoxy resin;
• pliers;
• Needle file;
• scaffold;
• electrical tape.

1. In tyulpanchika pliers to remove the hanger and clean needle files. Its ring lift up five degrees.
2. Measure the desired length whip (everyone chooses for themselves), and cut. It is desirable that it was a non ends Strip.
3. From the whip rods ready to cut off the lower part, which is attached to the rod, drill a hole in it and the new paste there.
4. On the other end of the whip to put gum in order to nod, paste and paste tyulpanchik.
5. Take a nod from the clock spring, put on his 2-3 cambric segment to maintain a line and stick to the gum, leaving a small tip for fixing. The nod should be a few millimeters longer than the whip. Typically, the length of 15 cm.
6. Tip nod after gum fix tape.
7. wound on line and insert the rod in the whip.
8. Lesko threaded through the gum and the sleeve on the nod. He got the nod "Flapper" for winter fishing rod.

Storozhok should ogruzit correctly. To do this, use the load of not more than 4 years

Spring about gum folded back, and the top - down slightly, ensuring that the nod with a cargo did not reach the ring whip 1cm Working tackle for catching ripus ready..

Fishing for walleye

This fish is not easy to find in the winter, it is necessary to try to catch a few places to find the location of its habitat. In winter pike eats little time, so pick the right bait for him.

Lightweight and durable rod with a reel suitable for predator fishing. Whip and a nod for winter fishing rod on the perch should be sufficient rigidity. With a soft attack the bait fish will nod in time to see a bite and make cutting. The line should correspond to the selected lure or rocker. The amplitude of the oscillations of the balance for perch is 10 cm, and it is necessary to arrange the right game to them. Play should be short, making a slight rise of the rod up and then dropping.

It is possible to catch and vertical baits, they are catching capacity balancers. Winter is preferable to use a spinner with a slow game, gradually raising fished up and dropping sharply. Sweeps worth doing very vigorously, because the walleye hard fall. Search perch is necessary where there are snags, prevails solid bottom and there are differences of depth.

There is no nods, which you can catch different fish in any pond. Fishers should be all the time to try a variety of lodges, buying them in the store and manufacturing their own. Only in this case, the success of a successful fishing is guaranteed.